Description
A 40 x 5mm mild steel flat bar gives fabricators, builders, and DIYers a sturdy 40mm wide by 5mm thick section that’s easy to cut, drill, bend, and weld. Because it’s plain mild steel rather than galvanised, you don’t need to grind off zinc coatings before welding.
Apply primer, paint, or a protective finish after fabrication if the steel will sit outdoors or in damp spots. Always check your engineer’s spec before using mild steel flat bar in structural load-bearing jobs.
-
Profile Size: 40mm wide x 5mm thick
-
Standard Length: 6.0m (6000mm)
-
Material & Finish: Uncoated mild steel (weld-ready; paint or prime for outdoor exposure)
-
Common Uses: Welding brackets, gates, frames, supports, trims, and workshop fabrication
| Spec | Details |
|---|---|
| Section Size | 40mm width x 5mm thickness |
| Standard Length | 6.0m (6000mm) |
| Material | Mild steel (uncoated) |
| Workability | Suitable for welding, drilling, cutting, bending, and painting |
Frequently asked questions
What is a 40 x 5mm mild steel flat bar used for?
Fabricators and builders use 40 x 5mm mild steel flat bar for welded brackets, frames, gate hardware, supports, trims, and general workshop projects.
Does mild steel flat bar need painting or rust protection?
Yes, because mild steel is uncoated, it will surface-rust in damp or outdoor conditions unless you prime, paint, or seal it after cutting and welding.
How should I choose between mild steel and galvanised 40 x 5mm flat bar?
Pick mild steel flat bar when you plan to weld and paint the finished piece, or choose galvanised flat bar when you want built-in zinc rust protection for outdoor bolt-on jobs.



